FILTRATION
A typical compressed air system is contaminated with abrasive solid particles such as dust, dirt, rust and scale, compressor lubricants, acidic condensate and oil/hydrocarbon vapors.
If not removed, these contaminants increase pneumatic equipment maintenance costs, lead to instrument and control failure, contribute to product rejection and contaminate processes.
The right Hankison filter or filter system will remove these contaminants allowing your compressed air system to deliver the quality of air required by your application..... whether it's plant air, instrument air or medical air..... helping to ensure consistent output quality while minimizing operating costs.
Hankison HF Series compressed air filters are available to provide the exact degree of filtration needed for your application. Capacities range from 20 to 780 SCFM (34.4 to 1326 Nm3/Hr).
A wide selection of elements are offered to ensure that you remove the necessary contaminents with minimal pressure drop.
An important fact to remember is that each 2 PSIG of pressure drop results in a 1% increase in required compressor power!
|
|
|
|
|
Grade 9 Separator/Filter Suitable for 99% bulk liquid plus 3 micron particulate removal. |
Grade 7 General Purpose Air Line Filter Suitable for removal of 1 micron solid particulates |
Grade 5 High Efficiency Oil Removal Filter Suitable for coalescing fine water and oil aerosols to 0.008 ppm (0.01 mg/m3) |
|
|
|
|
Grade 3 Ultra High Efficiency Oil Removal Filter Suitable for coalescing ultra-fine oil aerosols to 0.001 ppm (0.001 mg/m3) |
Grade 1 Oil Vapor Removal Filter Suitable for removal of oil and hydrocarbon vapors normally absorbable by activated carbon and for removing solid particles to 0.01 micron. |
